Dell PowerEdge R630 E26S Serie Manual Del Propietário página 132

2. Follow the procedure listed in the Before working inside your system section.
3. Keep the Philips #1 screwdriver handy.
NOTE: If the sistema has three PCIe cards, ensure that you install the PCIe cooling shroud in your sistema.
1. Orient the NDC so that the Ethernet connectors fit through the slot in the back panel.
2. Align the captive screws at the back-end of the card with the screw holes on the system board.
3. To ensure that the connector on the card is in contact with the connector on the system board, press the touch point on the
card.
4. Tighten the two captive screws to secure the NDC to the system board.
5. Install the expansion card riser 3.
Figure 60. Installing the NDC
1. captive screw socket (2)
3. captive screw (2)
5. NDC
Follow the procedure listed in the After working inside your system section.
Related references
Instrucciones de seguridad
Related tasks
Antes de manipular el interior del sistema
Installing expansion card risers
Después de manipular el interior del sistema
Removing the network daughter card
132 Instalación y extracción de los componentes del sistema
on page 81
on page 82
on page 121
on page 82
on page 130
2. connector on the system board
4. touch point (2)
6. back panel slots for Ethernet connectors