Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Step 3: Fitting Cross Bars to the vehicle
a)
Place an end support into the plastic adaptor and
loosely bolt down by inserting the 40mm bolt into the
anchor point threads and turning approx 2-3 turns with
the L wrench security key. Do not tighten yet, repeat for
the opposite side. (figure 5)
b)
Place the cross bar onto the end supports ensuring that
the end support tabs are located into the cutouts on the
underside of the bar. Check that the cross bar is has
equally distanced overhang on either side of the end
supports. (figure 6)
c)
Insert the M8 hex nut into the clamp block. Insert the
clamp block into the end of the cross bar and align it so
that the nut and the end support's bolt hole align.
Tip: Tape M8 nut to Clamp Block to hold nut in place.
d)
Secure the cross bar to the end support by screwing the
M8 x 20mm bolt with flat washer and lock washer
through the end support hole and into the clamp block
nut. (figure 7)
e)
Using a 13mm or adjustable wrench, fully tighten the
bolt on the underside of the support. Now using the
security key finish tightening the 40mm bolts to 5Nm (44
in/ lbs) or to a firm hand tightness.
Step 4: Installing under cover strips (figure 8)
a)
Mark on bars with a pencil the length of under cover
strips needed.
b)
Remove bars by removing the M8 bolt.
c)
Measure length of under cover filler strips to fill slot.
d)
Cut under cover pieces using scissors or a hacksaw.
e)
Slide inner most under cover into position on the
bars and re-assemble bars onto vehicle.
f)
Add the outer under cover piece once bars are
attached.
Step 5: Install end caps
The locking end caps can now be installed into the ends of
the cross bars. Remove keys and keep in a safe place.
To load accessories into the cross bar accessory channel
remove end cap, cut buffer strips as needed. Once
accessories have been loaded, re-insert the end caps and
lock. Additional buffer strips may be purchased from
ROLA if needed.
REGULARLY CHECK THE TIGHTNESS OF CROSS BAR ATTACHMENTS.
Loads should be evenly distributed and secured
Check the function of all doors and sunroof before driving.
Any weight carried on the vehicle will adversely affect its handling particularly in cornering or in a cross wind and the vehicle
should therefore be driven with increased caution.
For lost key replacement or other service items call customer service: 1-800-632-3290 or visit:
Please have lock core number or part numbers available.
Only use NON-STRETCH tie down straps.
A number of accessories for carrying special loads are available.
59632N
Rev A 6-19-15
Fitting Instructions
Dodge Promaster City
Without Factory Side Rails
Clamp block
End cap
.
Printed in China
PART No:
CARRYING CAPACITY:
40 mm bolt
Anchor hole
Cross Bar
Center Cross Bar
On Vehicle
Figure 6.
Figure 7.
Inner Under
Caution!
cover strip
Sharp edges
Slide
to end
End Cap
Figure 8.
Ensure bars are parallel and straps are tightened against
the side rails. Perform a check by tugging on the cross bars.
www.rolaproducts.com.
59631, 59632, 59633
75 Kg/
165 Lbs
L wrench- security key
tabs
end support
Figure 5.
M8 nut
Flat washer
Lock washer
M8 bolt
Buffer Strip
Outer under
cover strip
Pg 2 of 2
Tabla de contenido
