Installing The Light Kit And Glass - Kichler Bead 54 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

INSTALLING THE LIGHT KIT AND GLASS

NOTE:
NOTE: Before continuing installation, confirm that the power is still turned off
Before continuing installation, confirm that the power is still turned off
at the main circuit breaker or by removing the circuit fuse. Turning the power
at the main circuit breaker or by removing the circuit fuse. Turning the power
off using a wall switch is not sufficient to prevent electrical stock.
off using a wall switch is not sufficient to prevent electrical stock.
Step 1. Hold the light kit close to the switch housing and connect the WHITE
Step 1.
Hold the light kit close to the switch housing and connect the WHITE
wires from the light kit and fan by pushing the connectors together. Follow
wires from the light kit and fan by pushing the connectors together. Follow
the same procedure with the BLACK wires. (Fig. 15)
the same procedure with the BLACK wires. (Fig. 15)
Step 2. Tuck the connections neatly into the light kit. Remove one of three
Step 2.
Tuck the connections neatly into the light kit. Remove one of three
screws pre-installed on the switch housing and keep for later use. Loosen the
screws pre-installed on the switch housing and keep for later use. Loosen the
other two (do not remove). Place the two slot holes on the light kit over the 2
other two (do not remove). Place the two slot holes on the light kit over the 2
screws previously loosened from the switch housing. Rotate the light kit until
screws previously loosened from the switch housing. Rotate the light kit until
it locks in place at the narrow end of the key holes. Secure by tightening the 2
it locks in place at the narrow end of the key holes. Secure by tightening the 2
screws previously loosened and the one previously removed. (Fig. 15)
screws previously loosened and the one previously removed. (Fig. 15)
Step 3. Secure the glass to light kit assembly and twist clockwise. Do not
Step 3.
Secure the glass to light kit assembly and twist clockwise. Do not
over-tighten.(Fig. 16)
over-tighten.(Fig. 16)
12 | KICHLER.COM
Light Kit
Fig. 15
Glass
Fig. 16
Tabla de contenido

Solución de problemas

loading

Tabla de contenido