Uline H-3107 Guia De Inicio Rapido página 3

ASSEMBLING CABINET
1. Place the back (1) on a protected surface.
The bottom flange should be facing upward.
2. Attach the left side (2) and right side (3) to the back
by placing flange around the back and bolting the
back and sides together with seven bolts and nuts
on each side. Be sure that the lances (4) on all shelf
adjustment strips point in the same direction.
(See Figure 1)
4
3. To help hold the sides in position, insert the shelf (5)
into the top position of the shelf adjustment strips,
inserting the shelf edges into the lances on all four
shelf adjustment strips. Be sure that the channeled
edge of the shelf is toward the cabinet front.
(See Figure 2)
5
PAGE 3 OF 15
ASSEMBLY INSTRUCTIONS
Figure 1
2
1
3
Figure 2
4. Attach the top (8) to the unit by sliding the outer
flange over the back of the unit and the side flange
on the side panel of the unit. The threaded studs
should go through the holes in the top flange of the
side and fasten with three nuts. Attach the back to
the top using four bolts and nuts. (See Figure 3)
5. Attach the sill (6) to the two holes on each side
of the cabinet bottom. Flange faces upward.
(See Figure 4)
6
Figure 3
Figure 3
8
Figure 4
0321 IH-3107