Kohler K-98741 Guía De Instalación Y Cuidado página 8

6-3/4" (172 mm)
Soldering Template
Clamp each tee
to the template
during soldering.
2. Install the Supply Piping – Single Supply
Route the water supply lines.
Use the provided soldering template to construct a pressure
balancing loop.
Position tees in the loop over each of the four raised locations on
the template.
Solder the assembly while it is attached to the template.
Remove the pressure balancing loop from the template.
Connect the pressure balancing loop to the water supply.
Do not strap the pipes.
Temporarily install a nipple to each tee. Do not use any sealant.
1207716-2-C
Ø 9-5/8"
Pressure
(244 mm) Balancing
Loop
6-3/4"
(172 mm)
1/2" NPT Nipple
Pressure
Balancing Loop
8
Soldering
Template
Kohler Co.