Kohler K-98741 Guía De Instalación Y Cuidado página 20

Fuse
Access Cover
11. Connect the Cables
WARNING: Risk of electric shock. Make sure the power
cord is unplugged before removing the access cover.
IMPORTANT! When possible, connect the cables through the side
holes of the PDS rather than the cover holes to ease cover removal
for servicing.
Prepare cable ends for installation into the PDS by unthreading
the strain relief cap and separating the rubber stopper from the
threaded body. This will prevent the cables from twisting while
the strain relief is threaded into the box.
Insert the chroma power cable into a 1/2" NPT hole and install
into the "RAIN PANEL" connector until it snaps together.
Insert the chroma data cable into a 1/2" NPT hole and install into
the "DATA IN" connector until it snaps together.
Secure the cables and the electrical wire to the PDS using the
watertight strain relief fittings. Thread the fitting into the box,
then slide the rubber stopper into the fitting. Tighten the cap to
create a seal.
1207716-2-C
Strain Relief Fitting
PDS
Chroma
Power Cable
100-240 VAC
Chroma Data Cable
20
Cap
Kohler Co.