Care And Cleaning; Troubleshooting - Glacier bay FP2BC420CP Guía De Instalación Y Cuidado

Care and Cleaning

□
To clean, wipe down with a damp cloth and towel dry.
□
Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will
be voided.

Troubleshooting

NOTE: Refer to the service parts section in this manual
for a detailed drawing showing the location of the parts
listed below.
Problem
The aerator leaks or has a
reduced water flow.
There are leaks from
the hose underneath the
deck.
The hose does not retract.
The water pressure is low.
There is no hot or cold
water.
Possible Cause
□
The aerator is dirty or mis-
fitted.
□
The cartridge may be clogged.
□
The connection between the
pull-out spray and pull-out
spray hose may be loose.
□
The weight is not installed in
the correct position.
□
The pull-out spray hose is
obstructed.
□
The quick connector may be
clogged with debris.
□
The hot or cold water supply
lines may be kinked or twisted.
Solution
□
Remove the aerator and check for debris.
□
Remove the cartridge and check for
debris.
□
Ensure the aerator is properly installed.
□
Tighten the connection between the pull-
out spray and pull-out spray hose.
□
Reinstall or readjust the weight.
□
Check under the sink to ensure the pull-
out spray hose is not obstructed.
□
Turn off the water supply and disconnect
the quick connector from the outlet hose.
□
Disconnect the quick connector from
the pull-out spray hose and flush under
running water.
□
Reattach the quick connector to the
outlet hose.
□
Test water flow. If water pressure is still
low then replace the quick connector.
□
Ensure hot and cold water supply lines
are not kinked or twisted. Reinstall the
supply line if necessary.
8