Round, Inspiral, And Multi-Ring Burners - Cafe CGU366 El Manual Del Propietario

Care and Cleaning

ROUND, INSPIRAL, AND MULTI-RING BURNERS

CAUTION
Surface burners should be cleaned routinely, especially after bad spillovers, which could clog the slots and holes in
the burner heads.
The electrode is located at the rear of each burner. Do not attempt to disassemble or clean around any burner while
another burner is on. An electric shock may result.
To remove the burner parts:
1. Turn all controls OFF before removing any burner
parts.
2. When cool, you may lift off the burner grates, burner
caps and burner heads for easier cleaning. Do not
remove the burner bases.
NOTE: Be sure to replace the burners and grates in the
same location and orientation.
Cleaning
Lift off burner parts only when cool. Wash in hot, soapy
water.
To remove burned-on food, soak the burner heads in
a solution of mild liquid detergent and hot water for
20–30 minutes. For more stubborn stains, use a plastic
scouring pad or toothbrush.
If the spill goes inside the burner head assembly, wash it
under running water and shake to remove excess water.
After Cleaning
Before replacing the burner parts, shake out excess
water and then dry them thoroughly.
To replace the burner parts for Multi Ring:
Align the burner head as shown. Pass the igniter
through the opening in the burner head while ensuring
the ignitor arrow is pointing toward the ignitor. Make
sure the burner lies flat. Install the burner caps taking
care to check that they lie flat on the burner head.
Check burner operation to ensure uniform, blue flame
around the burner. If there are yellow or uneven flames,
immediately turn the burner off, let it cool, and readjust
the burner and burner caps.
12
Inner Burner
Cap
(Removable)
Outer
Burner Cap
(Removable)
Burner
Head
Electrode
Multi-Ring Burner
Inner Burner Cap
(Removable)
Outer
Burner Cap
(Removable)
Burner
Head
Burner
Base
Electrode
Single-Ring Burner Inspiral Burner
Cooktop without
burner installed.
Top View
To replace the burner parts for Round Burner:
Make sure that the burner parts are replaced in the
correct location and orientation.
1. Replace the burner head on top of the burner base,
making sure that the hole in the burner head is
properly aligned with the electrode in the burner base.
A small gap between the base and head is normal.
2. Place the burner cap on top of the burner head. Make
sure that the burner cap is properly seated on the
burner head.
Burner cap properly seated
To replace the burner parts for Inspiral Burner:
Follow graphics to align
spark ignitor
Electrode
Burner in correct Burner with outer
orientation. and inner cap.
Top View Top View
Burner cap not properly seated
Ignitor
49-2000661 Rev. 2