Care And Cleaning; Control Panel And Knobs; Rangetop Exterior; Stainless Steel - Cafe CGU366 El Manual Del Propietario

Care And Cleaning

CONTROL PANEL AND KNOBS

It's a good idea to wipe the control panel after each use.
Clean with mild soap and water or vinegar and water,
rinse with clean water and polish dry with a soft cloth.
Do not use abrasive cleansers, strong liquid cleansers,
plastic scouring pads or oven cleaners on the control
panel because they will damage the finish.
For easier cleaning, the control knobs may be removed
by pulling them directly outwards once the knobs are in
the OFF position. Do not pull knobs up or down or hang
objects on them. This can damage the gas valve shaft.
See the Surface Burner section for a detailed view of
these knobs. The knobs can be washed by hand with
soap and water.
When removing the burner knobs, remember their
location. The knobs are not interchangeable, these
knobs must be placed in the same location after
cleaning. See the Surface Burner section for a detailed
view of these knobs. To replace knobs after cleaning,
align the bottom of the knob with the matching clip
orientation to the shaft inside the bezel. Push knob until
completed seated.

RANGETOP EXTERIOR

Do not use oven cleaners, abrasive cleansers, strong
liquid cleansers, steel wool, plastic scouring pads, or
cleaning powders on the cooktop surface. Clean with a
water. Rinse with clean water and dry with a soft cloth.
When cleaning surfaces, make sure that they are at
room temperature and not in direct sunlight.
Spillage of marinades, fruit juices, tomato sauces and
basting liquids containing acids may cause discoloration
and should be wiped up as soon as hot surfaces cool,
Then clean and rinse.
49-2000661 Rev. 2
bezel. Do not remove diffuser film. Do not expose to
moisture or it will damage lighting electronics.
Front
Flat
Side
Burner Knobs

Stainless Steel

Do not use a steel wool pad; it will scratch the surface.
To clean the stainless steel surface, use warm sudsy
water or a stainless steel cleaner or polish. Always
wipe the surface in the direction of the grain. Follow
the cleaner instructions for cleaning the stainless steel
surface. Cleaners with oxalic acid such as Bar Keepers
Friend Soft Cleanser™ will remove surface rust, tarnish
of grit and rub in the direction of the brush lines with a
damp, soft sponge. To inquire about purchasing cleaning
products including stainless steel appliance cleaner or
polish, see the Accessories and Consumer Support
sections at the end of this manual.
Control Panel
Flat Side
11