Stiga PlayTheBest T8525 Manual Del Propietário página 7

SETTING TABLE UPRIGHT
CAUTION
8"
6. MAKING FINAL ADJUSTMENTS
If your gap between table halves is greater than 1/2" or uneven adjust it as follows.
20.Loosen the six bolts shown
below and adjust table so
that the space between the
two table top halves
measure a 1/2 inch or less.
21.Retighten these bolts.
22.Check over entire assembly
to be sure all nuts and bolts
are secure. Remember, do
not overtighten bolts at
joints that move.
At least two adults are needed to complete the following
steps. Be sure top halves are locked in safety latches! Be sure
that both locking casters are locked!
You must use a 8" stack of magazines (or similar block) to
protect the casters when lifting table upright!
17.Before lifting table, be sure both top halves are locked in
safety latches! Be sure casters are locked! Put a 8 inch stack
of magazines, wood, etc. under caster beam nearest the
floor to protect casters. (See Detail K).
18.With the help of one other adult, brace lower caster beam with
your foot and lift table upright. (See Detail L).
19.Once upright, release safety latch and lower table top halves.
See Detail M and OPERATING INSTRUCTIONS on next page.
7
1/2" or less