Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ATTACHING NAME PANELS TO LEGS
CAUTION
8. With a helper , hold top halves about 14 ½ inches
apart. Attach only top half of name panels #8 to
upright assemblies #11 as shown in Detail D.
NOTE: Use ONLY TWO bolts #26 and locknuts #28
on each name panel. (Two other bolts #27 and nuts
#28 will be used in the next section to attach the
other half of the name panels and linkages #24 at the
same time. See next page).
Do not tighten these locknuts completely tight yet .
AT LEAST TWO ADULTS ARE NEEDED TO COMPLETE THE
FOLLOWING STEPS! DO NOT LEAVE TABLE UNATTENDED UNTIL
ASSEMBLY IS COMPLETE!
Detail D
4
HELPFUL HINT: Start at the bottom and insert two
bolts #26 UPWARD through upright assemblies #11
and name panel #8. Then attach the upper name panel
#8. Insert bolts #26 DOWNWARD.
Tabla de contenido
