Installing Display Assembly - Dell Latitude 12 Manual Del Propietário

NOTE: DO NOT remove any cable or adhesive tape from the display panel, unless you are replacing the cables
separately.

Installing display assembly

1. Place the system chassis on a plane surface.
2. Place the bottom edge of the display assembly inside the bottom edge of the rear chassis.
3. Rest the display assembly by less than 90° angle.
NOTE: Use a support to attain the required angle.
4. Connect the touch cable, function keys cable, and LVDS cable to the connector on the system board.
5. Release the latch to secure the cables to the respective connecting ports.
NOTE: Make sure to insert the cable under the clips, if not, the system may not display video after reassembling.
6. Paste the adhesive tapes to secure the connected slots.
NOTE: Ensure to secure the adhesive tapes, to protect the display assembly from electrostatic discharge damage.
7. Align the display assembly on the tablet chassis and press the edges to snap-in.
NOTE:
● Ensure that the Window button on the display assembly aligns with the docking pogo pins on the system
board chassis.
● Press the edges starting from Windows button clockwise until they snap-in evenly from all sides. Ensure
to hear a click sound when the display assembly is aligned in correct position.
8. Flip the system so that the battery is at top view.
NOTE: Ensure to place the system in a flat surface.
9. Replace the screws (19) to secure the display assembly to the tablet.
Extracción e instalación de componentes 19