Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Adjust the distance between the end of the eye
shield and the grinding wheel regularly to
compensate for grinding wheel wear. The distance
should never be less than 2 mm. If the distance is
greater, it is no longer protected against the material
ejection.
If it is not possible to adjust the distance between the
grinding wheel and the end of the eye shield, replace
the grinding wheel.
Installing the tool rest
The workpiece tool rest (10) can be adjusted according
to the workpiece and the desired grinding angle.
1. Place the tool rest in the fixing holes and tighten the
supplied screws, washers and nuts;
2. Adjust the tool rest to the desired position and angle.
The maximum distance between the tool rest and the
grinding wheel must always be less than 2 mm;
3. Tighten the tool rest adjustment knob (11);
Adjust regularly the distance between the tool
rest and the grinding wheel to compensate for
grinding wheel wear. The distance should never be less
than 2 mm. If the distance is greater, the workpiece can
be dragged by the rotation of the grinding wheel and
cause injury.
If it is not possible to adjust the distance between the
grinding wheel and tool rest, replace the grinding
wheel.;
Grinding wheel replacement
Do not use damaged grinding wheels. Ensure the
grinding wheel is not damaged in any way such as
cracks, deformations or fissures. After having installed
and checked the condition of the grinding wheel, make
sure you and others nearby keep their hands away from
the grinding wheel and let the appliance run at the
maximum speed for a minute. Most damaged grinding
wheels are likely to break during the test period.
The grinding wheels must be able to run at least the
rotation speed of the bench grinder. If this does not
happen, the accessories may be damaged and cause
injury to the user and damage to the work area.
Replace the grinding wheel whenever the diameter of
the grinding wheel is less than 10 mm.
Dry grinding wheel:
1. Unplug the power cord;
2. Loosen the 3 retaining screws (12) and remove the
grinding wheel guard (6);
3. Hold the grinding wheel (9) firmly and loosen the
locking nut;
4. Remove the locking nut, the outer flange and the
identification label, which provides information
about the characteristics of the grinding wheel;
5. Remove the worn-out grinding wheel and replace it
with a new one;
6. Install the grinding wheel into the spindle and fit
against the inner flange;
7. Place the outer flange and tighten the locking nut;
8. Fit the guard and tighten the retaining screws;
9. Switch on the bench grinder and allow the grinding
wheel to run with no load for 1 minute. Check that
the grinding wheel rotates freely;
Wet grinding wheel:
1. Unplug the power cord;
2. Drain all water from the tank by unscrewing the drain
plug (3);
3. Loosen the 3 retaining screws and remove the water
tank (4);
4. Hold the grinding wheel (5) firmly and loosen the
locking nut;
5. Remove the locking nut and outer flange;
6. Remove the worn-out grinding wheel and replace it
with a new one;
7. Install the grinding wheel into the spindle and fit
against the inner flange;
8. Install the outer flange and tighten the nut;
9. Fit the water tank and tighten the fixing screws;
10. Switch on the bench grinder and allow the grinding
wheel to run with no load for 1 minute. Check that
the grinding wheel rotates freely and proper balance;
27
Tabla de contenido
