• It is dangerous to use or gain access to appliances pow-
ered by the electrical system of the building when inside
the shower enclosure.
WARNING!
Steam comes out at temperatures of
about 100°C. Keep legs away from the steam outlet
during the steam bath, or at least 40 cm away from the
nozzles.
• In the Turkish bath, the temperature reached at full oper-
ating power, inside the various model and at chest level
of the person using the function, is about 45°C, starting
from an initial temperature in the shower enclosure (or
in the room) of about 20 °C.
• When there is a high ambient temperature, or if consec-
utive Turkish bath cycles are run (e.g. fitness centres, gym-
nasiums, etc.), the temperature in the shower enclosure
may exceed 50°C. The seat of the shower column, because
of the specific characteristics of the material it is made of,
tends to reach the same temperature, which some may
find too hot to the touch. In these cases it is advisable to
use a towel or similar insulating material to prevent di-
rect contact with the aforementioned parts.
• Do not use water at temperatures over 60°C: the water cir-
cuit might get damaged and there is a higher probabili-
ty that lime scale deposits will form.
• After using any "water jet" function, turn off the stop tap. It is ad-
visable to turn the diverter to the "showerhead" position.
• After using the electronic functions, turn off the master switch
(see Electrical safety chapter).
• If the electric current is cut off during the steam bath, the steam
bath is interrupted and the boiler will not be washed. When the
electric current is restored, it is, therefore, advisable to re-start the
steam bath for about 3 minutes and then switch it off.
• If MYNIMA shower enclosures are supplied with hot water from
an economic-type gas boiler with mechanical flame adjustment,
the boiler may not be able to provide a continuous water sup-
ply at the required temperature. In this case, if it is not possible
to replace the boiler with an electronic-modulation one, it is ad-
visable to get a qualified technician to lock the flame modula-
tion of the boiler and only use the shower enclosure mixer tap
to regulate water temperature.
• The water supply (hot/cold water) must ensure well-balanced
pressures. A considerable difference in pressure may prevent
correct and speedy adjustment of the water temperature.
For all maintenance and/or repair operations that require
the replacement of components, original Jacuzzi
parts must be used, since failure to comply with this regu-
lation will mean that the Manufacturer is not liable for
any damage.
®
spare
13