Auto Standby; Ringer Hi/Low/Off; Flash/Call Waiting On Land Line Service; Flash/Call Waiting On Cellular Service - RCA 23200 Manual De Instrucciones

Auto Standby

If you place the handset in the cradle while the handset is off the hook (during a call), the call is
automatically disconnected.

Ringer HI/LOW/OFF

NOTE: This setting is for the land line only.
There are two ways to set the cordless handset ringer to HI/LOW/OFF. One is the traditional way as
described in the Programming Functions; Handset Setup; Ringer Volume menus. The other one is this
short cut to ringer menu.
1. Make sure the cordless handset is OFF (not in talk mode).
2. Press the #pause/ringer on-off button to display SET RINGER 1HI 2LOW 3OFF.
3. Use the touch tone pad on the handset to select 1, 2 or 3, or use the CID/vol or buttons to
scroll to your selection. 1HI is the default setting.
4. Press #pause/ringer on-off button again to save and display the new selection for a few seconds.
NOTE: This feature ONLY applies to the cordless handset and not the cell phone ringer.

Flash/Call Waiting on Land Line Service

If you subscribe to the combined Call Waiting Caller ID service from your local telephone company, you
will receive Caller ID information (if available) on Call Waiting calls. During a phone call, you will hear a
beep to indicate another call is waiting on the line and Caller ID information for the waiting call shows
on the handset display.
• To connect to the waiting call, press the flash/exit button on the handset, and your original call
is put on hold.
• To switch between the two calls, press the flash/exit button.
TIP: Do not press the home button on the handset to activate a custom calling service, such as
call waiting, or call will disconnect.

Flash/Call Waiting on Cellular Service

Your cell phone may offer call waiting as a stand-alone device if you subscribe to the Call Waiting
service from your cellular service provider.
Some—but not all—cell phones also allow call waiting access through the adaptor cable and the docking
station. When using the cell dock system, you will hear the call waiting beep from your cellular provider.
Press the flash/exit button on your handset to see if you can access the incoming cell call. If your cell
phone allows access through the adaptor cable, you will be connected to the incoming call.
Press the flash/exit button again to switch back to the original caller.

Last Number Redial

You may redial a number up to 32 digits long.
To quickly redial the last number you dialed:
1. Press the home button.
All manuals and user guides at all-guides.com
Basic Operation
27