Motorola HLN7016 Manual Del Usuario página 5

Mounting the Adjustable Angle Bracket
Once an installation location has been decided, refer to
Figure 1 and perform the following steps:
1. Verify that the selected mounting surface is strong
enough to support the mounting hardware and handset.
2. Using the base of the adjustable angle bracket as a
template, mark the desired mounting location. Remove
the bracket and center punch the spots previously
marked. Replace and realign the bracket in the
previously marked areas. Secure the brackets using the
self-drilling screws #10-16 x 1" long screws provided.
Be careful not to damage any wires or any other vehicle
components when drilling the holes.
3. Use the four #10-16 x 1" tapping screws and the
internal lockwashers provided to mount and secure the
bracket.
4. Place the hang-up cup on the bracket as shown in
Figure 1. Secure the hang-up cup to the bracket using a
T-20 Torx-head driver to the enclosed M4 x 10 mm
screw and M4 nut.
5. Select the angle between the two bases of the
adjustable angle bracket (from 0
the two adjusting screws.
to 110
°
3
) and tighten
°