D) Recommendations; E) Adjusting The Temperature - Roca ATAI 5A2734 Manual De Instrucciones

so that horizontal template -51- supplied enters freely and keeps the upper level in
horizontal position. The two groups must be placet with the same distance to the wall
-A-, checkig it with the orizontal tamplate -50- (the depth of the groups has to stay
between min and max level on the plate). After positioning the eccentrics, use hori-
zontal template -51- previously inserted on them to drill into the wall using the hole
located at the centre of the template as reference (first use a 5mm bit, then an 12mm
bit). Then insert anchor -54-.
Fig. E
Align one of the two holes of vertical template -52- with the previously inserted
anchor. Place the template vertically to the floor by using a level. Drill (first use a 5mm
bit, then an 8mm bit) into the wall using the hole on the vertical template, insert the
second anchor -45- and tighten screw -53- into it. Keep a distance of 1.5mm from the
wall under the head of the screw.
Fig. F
Insert the slot of upper curve -35- on the head of screw -53-, insert screw -43-
and washer -44- into the hole of main column -34- and tighten anchor -50-.
Position the tap by inserting eccentrics -47- and elbow -42- into their holes.
Move the tap to the wall, tighten grub screws -20- at the bottom of the tap with
a 4mm hexagonal wrench.
RECOMMENDATIONS: (Fig. B)
To obtain temperatures over 38°C, push the button on handle -3- and turn counter-
clockwise to adjust; for lower temperatures, simply turn the handle clockwise. To deli-
ver water to the top shower head, turn handle -16- counterclockwise; to deliver water
to the shower handle, push the button on handle -16- and turn clockwise. Clean with
water and neutral soap only, using a sponge or a soft cloth.
Warning: Do not use abrasive or product wich are too acid
ADJUSTING THE TEMPERATURE: (Fig. B)
The mixers are tested at the factory. Nonetheless, should there be a difference bet-
ween the temperature shown on the selector and the mixer's, carry out the following:
remove the handle cap -1- loosen the screw -2- slide off the handle -3- and the tem-
perature blocking system -8- turn on the cold and hot water; using a thermometer,
rotate the cartridge rod -10- up to 38°C; assemble the temperature blocking system
-8- the indicator -E- must be aligned with point -C-. Assemble all components in
reverse order matching index -D- with the 38° C reference mark of the handle.
10