Display Mode Setting; Volume Setting - CASATELLI FILIPPO 12 E1C Generalidades - Advertencias - Instalación - Mantenimiento

10.3.2 Display brightness setting
It is possible to set the dimming of the display brightness when in standby mode.
a) Use the
b) Select the password "7" with the
c) Scroll with the
d) Use the and

10.3.3 Display mode setting

It is possible to set what should be shown on the display when the latter is in standby mode
a) Use the
b) Select the password "7" with the
c) Scroll with the
d) Set one of the following values with the
OFF
" "
•
1
" "
•
2
•
" "
3
" "
•
4
" "
•
e) Press the key

10.3.4 Volume setting

Set the volume level of the buzzer, according to your requirements:
a) Use the
b) Select the password "7" with the
c) scroll with the
d) Use the and
10.3.5 Fuel optimisation
pellets, etc.)
Generally speaking, if at the end of combustion, there is a lot of residue in the burn pot, you should change the
a) Use the
b) Select the password "
c) Scroll with the
d) Set one of the following values with the
1
" "
2
" "
3
" "
e) Press the key
52
arrow keys to go to the set-up menu
key and select the sub-menu
keys to set the desired brightness value (
arrow keys to go to the set-up menu
key and select the sub-menu
All the operating parameters will be displayed cyclically;
The temperature is displayed (detected by the room probe)
The current time is displayed
has been enabled.
arrow keys to go to the set-up menu
key and select the submenu
keys to set the desired volume level (
arrow keys to go to the set-up menu
7
" with the
key and select the submenu
004778350 - 16/07/2020
and press the
key;
[11]
OFF, 1 ... 5
and press the
key;
[12]
and keys:
and press the
key;
[13]
OFF,1 ... 5
and press the
key;
[14]
and keys:
key;
key;
key;
key;
key;
key;
key.
key;
key;
key.