Communication Setup - Xylem LOWARA Aquavar IPC Guia De Inicio Rapido

No Water/Loss of
Prime Fault
Suction Input
Set Up Low Suction
Protection Through
Digital Input 27?
Low Suction Cut-out
Set Up High Suction
Protection Through
Digital Input 29?
Under Pressure
Low System Cut-out
Set Up Pump
Protection Through
Digital Input 19?
Continue to Digital
Input Setup?

3.3.7 Communication Setup

Follow steps from 1 to 3 and then proceed as follows.
Setup Selection
Communication
Disabled
Not Set
Alarm
Delay
0secs
Disabled
Function
Off
Disabled
No
Yes
10. Select Enable to protect the pump against run-
ning dry and/or loss of prime, by monitoring power
at full speed and comparing the actual power to a
preset limit. See full Manual for more information
11. Set the Suction transducer details. See full Man-
ual for more information
12. If a Lack of Water device is connected to Digital
Input 27, set this value to Alarm to enable the stop of
the pump in case the Lack of Water device is tripped
13. Set the delay the system waits before asserting
Alarm in case the Lack of Water device is tripped
14. If a High Suction Pressure device is connected to
Digital Input 29, set this value to Alarm to enable the
stop of the pump in case the High Suction Pressure
device is tripped. See full Manual for more informa-
tion
15. Set the value of pressure for the activation of the
Under Pressure Function. The Under Pressure Func-
tion protects the pump and system by preventing the
pump from running below a specified low pressure
for a specified amount of time. See full Manual for
more information
16. Set Low System Cut-out functionality. See full
Manual for more information
17. Select Yes if a Pump Protection device is connect-
ed on Digital Input 19. In case of tripping of the
Pump Protection device the motor will coast to stop.
18. Select No to exit
1. Select Communication Setup
en - Original instructions
33