Würth Pneustar 2 Instrucciones Para El Manejo página 5

Advices for operation
• Inform yourself before infl ating a tyre of the correct
tyre pressure and do not exceed this value.
• Infl ate a tyre with the (+) button only in short inter-
vals and check the pressure increase between the
individual infl ating steps on the manometer 20.
• Press the (–) Taste to reduce the tyre pressure.
• In addition, the general safety notes in the safety
notes section must be observed.
Maintenance and Cleaning
• Before any work on the pressurised parts of the tyre
infl ator, it is to be completely relieved of pressure.
Open the condensation drain screw 715 until air
streams out. Wait until air no longer streams out and
close the screw again.
• Always keep the machine clean.
• For all inquiries and spare parts ordering, please
include the 7-digit article number of the unit.
• Check the fi ller valve 2 and the automatic fi ller 3
regularly for correct function and sealing.
• Drain the water from the unit at regular intervals.
For this purpose, place the unit on a level surface
and open the condensation drain screw 715 far
enough that water and air streams out. As soon as
only air streams out, the unit is drained of water and
the screw can be screwed in again.
National reg u la tions apply. In Germany, measuring
equipment for the checking of tyre pressure must be
calibrated according to the calibration law from July
11, 1968. The validity of the calibration is two years
after the end of the calendar year in which the meas-
uring equipment was last calibrated. The re-sponsibil-
ity for calibrating falls on the person that uses the unit
or makes it available.
For this Würth machine, we provide a 12 -month
guarantee against material and workmanship defects
from the date of purchase (verifi ed by invoice or
delivery document). Damage that has occurred will be
corrected by replacement or repair.
Damage caused by normal wear, overloading or
improper handling is excluded from the guarantee.
Claims can be rec og nised only when the machine is
presented undisassembled to a Würth branch offi ce or
a Würth fi eld service employee.
We declare under our sole responsibility that this prod-
uct is in conformity with the following standards or
standardization documents:
89/392/EWG last changed by 93/68/EWG as well as
EN 292.
Adolf Würth GmbH & Co. KG
ppa. Otto Steck
Subject to change without notice
Calibration
Guarantee
Declaration of Conformity
98
Karl Weidner
5