Ratio PRO XF20-E Manual De Instrucciones página 38

4. PLACE THE POLISHING PAD (NOT
SUPPLIED) (SEE FIG E1, E2)
Place the polishing pad securely on the rotary
plate and make sure it's centrosymmetric.
Otherwise the polisher vibrates badly.
E1
E2
OPERATION
1. BEFORE PUTTING INTO OPERATION
A) CHARGING THE BATTERY
NOTE:
The battery charger supplied is matched to the
Li-ion battery installed in the machine. Do not
use another battery charger.
The Li-ion battery is protected against deep
discharging. When the battery is empty, the
machine is switched off by means of a protective
circuit: The tool holder no longer rotates.
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery to cool down
before recharging.
When the battery pack is charged for the first
time and after prolonged storage, the battery
pack will accept a 100% charge after several
charge and discharge cycles.
B) TO REMOVE THE BATTERY PACK (SEE
FIG. F1)
Depress the Battery Pack Release Button firmly
first and then slide the Battery Pack out from
your tool.
38
F1
C) TO INSTALL THE BATTERY PACK (SEE
FIG. F2)
Slide the fully charged Battery Pack onto the tool
with sufficient force until it clicks into position.
F2
D) CHARGER (ACG18LD3/ACG1830D)
CHARGING YOUR BATTERY PACK (SEE FIG.
G1, G2)
Do not use any charger other than that
specifically provided for use with the equipment.
If the battery pack is very hot you must remove
your battery pack from the charger and allow
time for the battery to cool down before
recharging.
Please charge the battery to reach full before
storage. If the tool will not be used for long
periods of time, charge the battery every 3
months.
green
light
G1
red
light