Boot And Shutdown; Connect With Pc; Interface Introduction; Bottom Bar Of The Interface - Wolder miTab JUMP Manual De Usuario

carefully press the button in the pin hole.
9. Speaker

Boot and Shutdown

Boot: Press and hold the power button, the system will enter the boot
process, System has been started, entering the Android system.
Shutdown: Press the power button, pop-up device options, select
Power off, Click OK, you can safely shut down.

Connect with PC

By Mirco USB (OTG) interface of the device, you can connect with PC by
Mirco USB cable attached with the device. USB Data transferring is available.
You can operate the files through the PC.
When your device is connected successfully, to pull up the notification area of
the status bar, can see the following icon
Then click
C lick
Note: The device also supports the FAT32 format for external devices, for
example U disk, Micro SD card to Transfer data.

Interface Introduction

Bottom bar of the Interface

A. WIFI signal status icon: If connected to the WIFI wireless network,
the icon will be displayed
B. OTG connect icon: If the device connected to the PC, will show the OTG
connected icon.
C. Time display: Display the time of the current system, which has been set.
to enter the next.
, Then the device can transmission data with PC.
7
，
,