CASUALPLAY Multiprotector Fix Instrucciones página 26

How to take the child out of the MULTIPROTECTOR FIX (group 2-3)
Unfasten the vehicle seat belt.
•
Take the child out of the restraint system.
•
Fasten the seat belt again.
•
Removing the MULTIPROTECTOR FIX from the car (group 2-3)
Unfasten the vehicle seat belt and pass it through the guides
•
If the fix connectors have been used, disconnect them by pulling the buttons
•
on both sides of the release devices. If done correctly, a red signal will
appear (fig.31).
Take the restraint system off the vehicle seat.
•
Dismantling the MULTIPROTECTOR FIX
If you want to store the MULTIPROTECTOR FIX, the backrest can be
•
detached from the base by pressing the button found on the rear lower part
of the backrest and pull the backrest upwards.
WARNINg: When the child is not using the restraint system, do not leave the
seat or the Impact Shield loose in the car. Fasten the seat belt.
Removing the upholstery
Detach the backrest from the base.
•
For the upholstery on the backrest, unfasten the zips, undo the fastening
•
straps and the plastic strips.
For the upholstery on the base, undo the fastening straps found underneath
•
the base.
For the upholstery on the Impact Shield, take the fabric out of the grooves
•
and remove it.
For the upholstery on the headrest, unfasten the 3 clasps and the 2
•
elastic strips found on the rear of the backrest. Lastly, pull the fabric cover
downwards.
To fit the different upholsteries, follow the same steps in reverse order.
•
Maintenance
Clean the plastic parts with soap and warm water.
•
Follow the washing instructions on the care labels sewn onto each fabric
•
part.
24
.