Taurus Ancona Manual Del Usuario página 20

the coffee maker assembly, turn the
ladle-holder backwards.
- Fix the filter holder into the coffee
assemblage by inserting it from below
the assemblage.
- Turn the filter holder in the coffee
maker assemblage from below the
assemblage and turn it from left to
right until it locks.
- Place one or two pre-heated cups at
the filter holder outlet as desired, and
then press the coffee release button.
The coffee infusion will begin to pour
out. It does not matter if the blue pi-
lot light goes out during this process.
When you have obtained the desired
quantity of espresso coffee (short or
long), press the coffee button.
- When the dispensing is completed,
wait a few seconds and then remove
the cups of coffee.
- Remove the filter holder and empty
out the grounds.
- Wash the filter holder with running
water.
- Check that the removable filter is
perfectly fitted into the filter holder.
- Fit the filter holder in the appliance
once more.
Preparing coffee with single-measure
bags:
- Remove the filter for ground coffee
from the filter holder.
- Insert the filter for single-measure
bags in the filter holder.
- Next, put the single-measure bag
into the filter holder, ensuring that
the paper of the bag does not protru-
de from the filter holder.
- Fix the filter holder into the coffee
maker assemblage by inserting it
Manual Ancona.indb 20
from below the assemblage.
- Turn the filter holder from left to
right until it locks.
- Place 1 pre-heated cup under the
filter holder;
- Press the coffee release button.
- Follow the "coffee preparation"
procedure.
- Remove the single-measure filter
and throw away the used bag.
Clean the filter holder and the single-
measure filter.
Obtaining hot water:
- Switch on the appliance by opera-
ting the on/off control.
- The heating pilot light will come on
indicating that the water is heating.
- Wait until the coffee release pilot
light also comes on. This situation
tells us that the water has reached
the appropriate temperature.
- Place a recipient under the vaporiser.
- Open the steam regulator by turning
it anticlockwise.
- Press the coffee release button.
- The hot water begins to pour out
through the vaporiser.
- Once you have obtained the desired
amount of hot water, press the coffee
release button.
- Close the control by turning it
clockwise.
Obtaining steam:
- The steam is used to foam milk for
cappuccino, and also to heat other
liquids.
- Switch on the appliance by opera-
ting the on/off switch.
- The heating pilot light will come on
indicating that the water is heating to
17/05/11 17:43