Kohler K-5806 Guia De Instalacion página 3

Nut
Rail
Bolt
1. Determine the Mounting Position
Determine the front-to-back length of the inside of the cabinet.
If necessary, cut the rails so they fit snugly with the cabinet walls.
Rails may be up to 1/8" (3 mm) less than the determined length.
Thread the bolts into the nuts two turns and then slide the nuts
into the slot in the rails. Slide the nut and bolt into the position
desired in the slots in the rails. Bolts should be located in the
outermost slots that will be under the corners of the sink.
With a tape measure, determine the overall width of your sink.
This distance represents the distance between outside edges of the
rails (A).
Using a mounting clip as a template, mark the screw placement
on the cabinet.
Drill 1/8" (3 mm) starter holes where marked.
Kohler Co.
Mounting
Clip
Rails
A
Front of Cabinet
3
Bolt
Rail
1032021-2-J