Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Taking Your Blood Pressure Reading
1. Position the monitor on a flat, stable surface with the digital display
panel in view. Insert the cuff tubing connector into the left side of the
monitor, Fig. 1. Avoid compression or restriction of the connection
tubing during measurement which may cause inflation error or harmful
injury due to continuous cuff pressure.
2. Rest your elbow on a solid surface with your palm facing upward.
Elevate your arm so that the cuff is at the same level as your heart,
Fig. 2. Relax your left hand, sit comfortably and don't cross your
legs. The middle of the cuff should be at the level of the right
atrium of the heart.
3. Press the POWER Button again to turn the unit on.
4. This unit will run a self-test, Fig. 3, and show the last measured
reading, Fig. 4, or if there is no previous measurement,
"0" as show in Fig. 5.
5. When the display appears
as shown, Fig. 6, the monitor
is ready.
Note: If a downward arrow (
)
flashes, there is air remaining in
the cuff. The air will be released
by the "Automatic Electronic Air
Release Valve" until "0" appears on the display.
To release the air quickly press the release button.
6. Using your right hand, squeeze and release the inflation bulb at a steady
pace. The inflation pressure must be 50-60 mmHg above your normal
systolic pressure. If the pressure in the cuff is insufficient, an upward
arrow (
) will flash. Continue to steadily inflate the cuff to the
proper level. Once the unit beeps, stop inflating the cuff. The unit will
automatically begin to deflate.
7. Upon completion, your blood pressure (systolic and diastolic) measurement
will display with the downward arrow (
the release button to release the residual air quickly, Fig. 7.
8. Your measurement will be automatically saved in the memory.
9. To conserve the batteries, press the POWER button to turn the power off.
Otherwise, the unit will automatically shut off after approximately 1 minute.
10. Disconnect the tubing from the monitor prior to storing.
Fig. 1
Fig. 3
Fig. 4
Fig. 5
Fig. 6
) flashing to let you know to press
Fig. 7
14
Recalling Measurements in Memory
You can recall up to 60 total measurements in memory. These measurements
can be shared with your physician or trained healthcare professional.
1. Press and release the MEMORY button. It will show how many
measurements are stored within the bank, followed by the last
result, Fig. 1.
2. Press the MEMORY button again to scroll through the saved measurements.
After you've scrolled through all the readings, the unit will automatically
turn off.
NOTE: When the number of readings exceeds 60, the oldest data will be
replaced with the new record.
Fig. 2
To erase all stored measurements:
1. Press and release the MEMORY button. The unit will display how many
measurements are stored within the bank.
2. Press and hold down the MEMORY button until two horizontal lines flash.
This indicates that all measurements have been erased, Fig. 2.
Fig. 1
Fig. 2
15
Capítulos
Tabla de contenido
