Maxon 297161-01 Manual De Instrucciones página 5

Idiomas disponibles

Idiomas disponibles

Always route electrical wires clear of moving parts, brake lines, sharp
edges and exhaust systems. Avoid making sharp bends in wiring. Attach
securely. If drilling is necessary, fi rst check behind the drilling surface so
you do not damage fuel lines, vent lines, brake lines or wires.
4. Insert control switch wiring into the
3/4" hole on the corner post and run it
down, out and under the vehicle body
to the pump assembly. (See dashed
line - FIG. 5-1.) Secure wiring to
vehicle body using frame clips and/or
loom clamps with self tapping screws
(Kit items). Then, attach switch in cor-
rect position on corner post.
© MAXON Lift Corp. 2018
LIFT CORPORATION Sht. 5 of 16 DSG#
CAUTION
!
M-16-17
SELF-TAPPING
SCREW
3/4" HOLE
CONTROL SWITCH WIRING
FIG. 5-1
Rev. A Date: 08/01/18
CONTROL SWITCH
CONTROL SWITCH
WIRING
PUMP
ASSEMBLY
loading