Unpacking; Assembly; All Models - Procom Heating 110 Manual Del Propietário

14. Never leave a heater plugged in without
adult supervision if children or animals are
likely to be present.
15. Use caution when moving or storing
heater when fuel tank contains fuel. Fuel
spillage can occur.
16. Use heater only in accordance with lo-
cal ordinances and codes. Canadian
residents should refer to CSA standard
B139, Installation Code for Oil Burning
Equipment for recommended installation
practice.
17. Never use gasoline, crankcase drainings,
naphtha, paint thinners, alcohol or other
highly flammable fuels.
18. Never use heater where gasoline, paint
thinner or other highly flammable vapors
are present.
19. Never use heater in living or sleeping
areas.
20. Never move, handle, refuel or service a
hot, operating or plugged-in heater.
1. Remove all packing items applied to
heater for shipment.
2. Remove all items from carton.
WIRE GUARD

All Models

1. Grasp Wire Guard from top of shell and pull towards front of heater until it locks into
place in slots on both sides of upper shell.
160108-01
SAFETY

UNPACKING

ASSEMBLY

Figure 1 - Wire Guard moved to locked position
www.usaprocom.com
Continued
21. Never attach duct work to front or rear of
heater.
22. Heaters used in the vicinity of tarpaulins,
canvas or similar enclosure materials shall
be located a safe distance from such ma-
terials. The recommended minimum safe
distance is 304.8 cm (10 feet). It is further
recommended that these enclosure ma-
terials be of a fire retardant nature. These
enclosure materials shall be securely fas-
tened to prevent them from igniting or from
upsetting the heater due to wind action.
23. Unplug heater when not in use.
24. Never block air inlet (rear) or air outlet
(front) of heater.
25. Warning to New York City Residents
For Use Only At Construction Sites in
accordance with applicable NYC codes.
26. Never use external fuel sources or tanks
that are not specifically designed for use
with this heater.
3. Check items for any shipping damage. If
heater is damaged call ProCom Heating,
Inc. at 1-877-886-5989 for replacement
parts before returning to dealer.
3