7. Minimum clearance from any combustible
materials: 8 feet (244 cm) from hot air
outlet, 6 feet (183 cm) from top, and 4
feet (120 cm) from sides and inlet.
8. Locate heater on a stable and level sur-
face while hot or operating or a fire may
occur.
9. Heater is acceptable for use on flooring
such as wood (a combustible material).
10. Use only in well vented areas. Before
using heater, provide at least a 3 ft
(2800 cm
) opening of fresh, outside air
2
for each 100,000 Btu/Hr (30 kw) of rating.
11. Keep children and animals away from
heater at all times.
12. Never start heater when combustion
chamber is hot or if fuel has accumulated
in combustion chamber.
13. This heater is equipped with a thermostat.
Heater may start at anytime.
14. Never leave a heater plugged in without
adult supervision if children or animals are
likely to be present.
15. Use caution when moving or storing
heater when fuel tank contains fuel. Fuel
spillage can occur.
16. Use heater only in accordance with lo-
cal ordinances and codes. Canadian
residents should refer to CSA standard
B139, Installation Code for Oil Burning
Equipment for recommended installation
practice.
1. Remove all packing items applied to
heater for shipment.
2. Remove all items from carton.
WIRE GUARD
All Models
Grasp wire guard from top of shell and pull
towards front of heater until it locks into place
in slots on both sides of upper shell.
160930-01A
SAFETY
17. Never use gasoline, crankcase drainings,
naphtha, paint thinners, alcohol or other
highly flammable fuels.
18. Never use heater where gasoline, paint
thinner or other highly flammable vapors
are present.
19. Never use heater in living or sleeping
areas.
20. Never move, handle, refuel or service a
hot, operating or plugged-in heater.
2
21. Never attach duct work to front or rear of
heater.
22. Heaters used in the vicinity of tarpaulins,
canvas or similar enclosure materials shall
be located a safe distance from such ma-
terials. The recommended minimum safe
distance is 10 feet (304.8 cm). It is further
recommended that these enclosure ma-
terials be of a fire retardant nature. These
enclosure materials shall be securely fas-
tened to prevent them from igniting or from
upsetting the heater due to wind action.
23. Unplug heater when not in use.
24. Never block air inlet (rear) or air outlet
(front) of heater.
25. Warning to New York City Residents
For Use Only At Construction Sites in
accordance with applicable NYC codes.
26. Never use external fuel sources or tanks
that are not specifically designed for use
with this heater.
UNPACKING
3. Check items for any shipping damage. If
heater is damaged call ProCom Heating,
Inc. at 1-866-573-0674 for replacement
parts before returning to dealer.
ASSEMBLY
Figure 1 - Wire Guard Moved to Locked
www.usaprocom.com
Position
3