Operation - Glacier bay F51A0074CP Guía De Instalación Y Cuidado

Installation (continued)
3
Installing the drain body
Install the main plunger (D), rubber washer (E)
and drain body (G) above the sink.
From below the sink, install the lock nut (F).

Operation

1
Flushing and checking for leaks
IMPORTANT: After installation is complete, remove the
aerator to flush the water lines. Do not lose the gasket in
the aerator.
Ensure the handles are in the off position. Turn on
the water supply and check for leaks. If you discover
any leaks, check your connections to ensure they are
installed properly.
Remove the aerator (B) and housing (if applicable). Turn
on the hot and cold handles to allow the water to run for
at least one minute. This flushes away any debris that
could cause damage to internal parts.
Turn off the water and reinstall the aerator and housing
(if applicable).
D
E
G
F
A
B
5
Please contact 1-855-HD-GLACIER for further assistance.
HOMEDEPOT.COM/GLACIERBAY