Simrad Marine TV
APPENDICES
A Maintenance
The satellite tracking system SIMRAD Marine TV does not require a lot of
maintenance. The following instructions are sufficient to sustain the optimal
capacity of the antenna unit:
• Clean the radome once a month, using fresh water and a mild detergent to
remove dirt and salt deposits.
• Do not detach the radome!
• Do not spray directly on the radome with high pressure water from a hose!
• Check cable connections to be tight and free of corrosion. Clean the cables
regularly.
The radome has a protective layer of UV-stabilized and maritime climate-
proof lacquer. Do not apply any additional paint, wax, preservative, solvent,
chemicals or adhesive labels. Any kind of coating will void warranty claims!
In case any solvent comes in contact with the radome by accident, rinse the
area immediately with water and, if necessary, with a mild detergent!
B Troubleshooting
Display
no dish
No connection to the
antenna unit
ErrorCom
Communication error with
antenna unit
Low Batt
Power supply too low
(>11.5V)
no Data
The satellite position re-
quested by the receiver in
Auto Sat
stored in antenna unit
Problem
mode is not
Remedy
- Check cable connection to antenna
unit (power and antenna cable)
- Check antenna unit's power supply
Turn unit off and on again
- Check power supply connection
for antenna unit (loose cable)
- Charge battery
- Check the DiSEqC
of the receiver
- Add satellite and store position
(see section 4.1)
English-33
TM
adjustment