Continuity Measurements - King Tony 9OM1371 Manual De Instrucciones

2-2-7 Continuity Measurements

Before taking any in-circuit measurement ,remove
power from the circuit being tested and discharge
all capacitors in the circuit.
Connect red test lead to " Ω "jack and black test lead to
1
"COM " jack.
Set Range Switch to "
2
Remove power from the circuit being tested and discharge
3
all capacitors.
Connect test lead to the circuit being measured.
4
When the impedance between the test jack is lower than
5
40Ω, it will activate a continuous beeper ( 2KHz).
Note: Continuity Test is available to check open/short
of the circuit .
Open circuit
WARNING!
" range , by pressing button.
Short circuit
19