Troubleshooting Guide - MIRKA LEROS 950XCV Instrucciones De Manejo

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION TO THE USER: Changes or modification not expressly approved by the party responsible for compliance could
void the user s authority to operate the equipment.
Maintenance
Always disconnect the power before maintenance!
Only use original Mirka spare parts!
Replacing the backing pad and interface
Tools required: Hex socket 19 mm, Torx T8 screwdriver and flat head screwdriver.
Remove hole screws (8 pcs).
1.
Remove the interface.
2.
3. Remove the cover cap. Untighten the screw to remove the backing pad.
4. Remove the screw.
Remove the old pad.
5.
6. Attach the new backing pad to the spindle (aligned correctly) and tighten the pad screw with the hex socket.
7. Attach the cover cap.
Fit a new interface.
8.
Refit hole screws (8 pcs).
9.
Replacing the brake seal
NOTE! Too much vacuum in your dust extraction system may cause the brake seal to malfunction.
1. Remove the backing pad as described above.
Pull the old brake seal out of its groove.
2.
Fit the new brake seal in the groove.
3.
4. Fit the backing pad as described above.
Further service
Servicing must always be performed by trained personnel. To keep the tool warranty valid and ensure optimal tool safety
and function, servicing must be carried out by a Mirka authorized service centre. To locate your local Mirka authorized
service centre, contact Mirka Customer Service or your Mirka dealer.

Troubleshooting guide

Symptom
The multi-purpose LED flashes
between red and green.
No light from multi-purpose LED
when switched on.
The multi-purpose LED is red and
the sander slows down to 4,000 rpm
when sanding.
The multi-purpose LED is red and
rpm is slightly reduced.
Possible cause
Connected to a mains outlet with
wrong voltage.
Power cord not properly attached to
the sander or to the mains socket.
Temperature too high in the sander.
Too heavy long term load.
Too heavy short term load.
Solution
Connect the sander to a mains outlet
that correspond with the nominal
voltage of the tool.
Connect it properly.
Reduce the load on the sander for
some time and the sander will speed
up again.
Use lighter load and the LED (right)
will automatically change to green.
en (original)
31