Safety Guidelines - Swan SB-1248 Manual De Instrucciones

Safety Guidelines

IMPORTANT NOTICE
IMPORTANT NOTICE: Indicates that equipment or
property damage can result if instructions are not
followed.
Read and Understand the Manual
It is the responsibility of any individual who
installs or maintains this product to fully
understand and follow proper installation and
maintenance procedures. Be aware of the inherent
dangers in the use of power tools when installing this
product. Read and understand all Warnings, Cautions,
and Important Notices in this manual.
Work Safely
DO NOT proceed if any doubt arises about the
correct or safe method of performing anything
found in this or other Swanstone manuals.
The installation of this product can require using power
tools. Do not use power tools without adequate training.
If necessary, hire or consult a trained professional for
expert assistance before continuing.
Use Proper Tools
Always use proper tools which are in good,
working condition during the installation of the
Swanstone products. Using tools other than
those listed could adversely affect the integrity of floors,
pipes, walls, or this product and could result in water
damage or other damage to floors, pipes, walls, or other
portions of your building or home.
Do Not Use Nails
Do not use nails to secure the bench seat
panel to the framing. The panel is mounted
with clear silicone only. Only use the supplied
or recommended clear silicone to attach this product.
Never use hammers, nails, or screws which could
adversely affect the integrity of this product. Nails and
screws could puncture the Swanstone Wall Systems and
Panels, resulting in water or other damage to floors,
pipes, walls, or other portions of your building or home.
Inspect Before Cutting
Make sure no electrical wiring or plumbing is
present before cutting into a wall.
Wall Conditions
Inspect the mounting surface before installing
the panel. Never install the panel over damp
material or an existing mold condition.
The Swan Corporation – Swanstone
CAUTION
CAUTION: Indicates a potentially hazardous
situation which, if not avoided, may result in minor or
moderate injury. It may also be used to alert against
unsafe practices.
Use Proper Installation Methods
Follow all instructions related to wall surface
preparation. Failure to follow such instructions
could cause the panels to detach from the wall
surface after installation, resulting in personal injury.
Failure to follow these instructions could result in water
damage.
Slipping Hazard
Do not install this product in the presence of
water. Installing this product without drying all
surfaces, or in the presence of water, could
cause you to slip and fall due to wet floors or spilled
fluids. Personal injury can result from slips or falls.
Before installation, dry all surfaces, including the floor,
with a cloth or paper towel. Clean up all water or spilled
fluids immediately.
Tripping Hazard
Personal injury can result from tripping over
power cords, tools, or other items. DO NOT
leave items laying around the work area.
Personal Protection
Be sure to use all personal protective
equipment, such as sturdy work
boots, preferably with steel toes,
gloves, and hard hat, if necessary, to ensure your own
safety. To prevent possible damage to your hearing,
always wear ear protection, such as earmuffs or
earplugs, when working around power tools.
Cutting Hazard
The installation of the Swanstone product may
require using power tools. Keep hands away
from the cutting edge of any tool used in the
installation of our product. Placing fingers in or around
the cutting blades could result in serious personal injury.
Sharp Edge Hazard
After cutting the edge of a Swanstone panel, it
can be sharp. Wear protective gloves to
prevent personal injury.
4 800-325-7008