General Instructions; Faucet Installation - T&S B-1171 La Instalación Y Las Instrucciones De Mantenimiento

General Instructions

Nozzle Installation:
Note: Nozzle should be installed first.
See diagram below:
1. Place no.17 over no.14. Insert
no.16 into each side of no.17.
2. Apply teflon tape or pipe joint
compound to threaded end of no.21.
Screw no.21 into no.17, rotate no.14
so that no 21 is facing front, tighten
no.16.
17
14

Faucet Installation:

3. Shut off water supply and drain
lines. Drill (4) four holes (3 holes for
B-1172), into countertop where you
are installing no.1
8" (for B-1172)
4" Min.
4" (for B-1171)
1-1/4 Ø
1" Ø
4" (for B-1172)
2" (for B-1171)
4. Place no.1 into the (3) three pre-
drilled mounting holes.
supply
5. Reinstall no.2 and no.3 back onto
no.1 shank under bottom of sink.
Connect water supply to no.1.
6. Tighten no.3 with a wrench.
21
Spray Hose/Diverter Installa-
16
tion
7. Disassemble no.22, place shank of
no.22 thru hole for no.23. Tighten
locknut of no.22.
1
23
8. Apply teflon tape to threaded end
of no.23. Insert no.23 through no.22
for no.23
and attach to no.1.
9. Turn on water supply and check for
leaks.
4
1
sink
2
3
water water
supply
22
sink
22