KALLISTA P22130 Guia De Instalacion página 4

Bonnet Nut
Spline Adapter
Valve Body
2. Install the Handle
All Models
Turn the bonnet counterclockwise and remove the bonnet from
the valve.
Thread the valve nut down the valve to allow for the thickness of
the mounting surface.
Close the valve (clockwise for hot and counterclockwise for cold).
Models with Spacer and Bonnet Nut
With the spacer on the valve, from below the mounting surface,
slide the valve through the correct (hot = left, cold = right)
mounting hole and thread the valve into the bonnet nut.
All Models
Thread the handle onto the valve by turning the body, making
sure the handle stays in the closed position and is properly
aligned.
Tighten the valve nut with a wrench, keeping the handle in the
final installation position.
Repeat the steps above to install the remaining handle assembly.
1008410-2-B
Handle
Mounting
Surface
Spacer
Valve Nut
4
Handle
Kallista