Regent HSL600 Instrucciones página 4

Idiomas disponibles

Idiomas disponibles

chain once again to turn the fixture off. NOTE: If the switch chain is
too short to reach, a 12" extension chain has been included which
can easily snap onto the bottom of the switch chain.
How to adjust the light direction of your fixture
To adjust the aiming function of your shoplight, loosen the two plastic locking
knobs located on top of the fixture just below the eye bolts. Grasping the
handles located on each end of the fixture, rotate the fixture to the desired
location, then retighten both plastic locking knobs.
WARNING: The halogen bulbs and fixture housing get hot during use. Do
not touch the bulbs or fixture housing until they have had time to cool.
WARNING: Deviation from the assembly instructions may result in a risk of
fire or electric shock.
SAVE THESE INSTRUCTIONS.
Five year limited warranty
Regent Lighting Corporation ("the Company") warrants this product (the "product") against defects
in material or workmanship for a period of five years from date of original purchase, and agrees to
repair or, at the Company's option, replace a defective product without charge for either replace-
ment parts or labor during such time. This does not include labor to remove or install fixtures.
This warranty is extended only to the original purchaser of the product. A purchaser's receipt or
other proof of date of original purchase acceptable to the Company is required before warranty per-
formance shall be rendered.
This warranty only covers product failure due to defects in materials or workmanship which occurs
in normal use. It does not cover the bulb or failure of the product caused by accident, misuse,
abuse, lack of reasonable care, alteration, faulty installation, subjecting the product to any but the
specified electrical service or any other failure not resulting from defects in materials or workman-
ship. Damage to the product caused by separately purchased, non-Company brand replacement
bulbs and corrosion or discoloration of brass components are not covered by this warranty.
There are no express warranties except as described above.
THE COMPANY SHALL NOT BE LIABLE FOR INCIDENTAL, SPECIAL OR CONSEQUENTIAL
DAMAGES RESULTING FROM THE USE OF THE PRODUCT OR ARISING OUT OF ANY
BREACH OF THIS WARRANTY. ALLIMPLIED WARRANTIES, IF ANY, INCLUDING IMPLIED
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE
LIMITED IN DURATION TO THE DURATION OF THIS EXPRESS WARRANTY. Some states do
not allow the exclusion or limitation of incidental or consequential damages, or limitations on how
long an implied warranty lasts, so the abo ve exclusions or limitations may not apply to you.
No other warranty, written or verbal, is authorized by the Compan y. This warranty gives you specific
legal rights and you may also have other rights which vary from state to state.
To obtain warranty service, please write to Regent Lighting Corporation, 2611 La Vista Drive,
Burlington, NC 27215. Enclose product model number and problems you are experiencing, along
with your address and telephone number. You will then be contacted with a solution, or a Return
Goods Authorization number and full instructions for returning the product. All returned products
must be accompanied by a Return Goods Authorization Number issued by the Company and must
be returned freight prepaid. Any product received without a Return Goods Authorization
Number from the Company will be refused.
Regent Lighting is not responsible for merchandise damaged in transit. Repaired or replaced prod-
ucts shall be subject to the terms of this warranty and are inspected when packed. Evident or con-
cealed damage that is made in transit should be reported at once to the carrier making the delivery
and a claim filed with them.
2611 La Vista Drive, Burlington, NC 27215 USA
Reproductions of this document without prior written approval of Regent Lighting Corporation are strictly prohibited
REGENT LIGHTING CORPORATION
1-800-334-6871
www.regentlighting.com
Patents Pending
4
loading

Este manual también es adecuado para:

Chsl600