Possible Problems; Technical Data - Italtecnica Fluomac Instrucciones Para El Uso

GB

6. POSSIBLE PROBLEMS

PROBLEM POSSIBLE CAUSES
The pump switches Leaks in the system.
on and off
continuously.
Dry stop even if Operating
there is water in the high.
suction pipe.
The pump do not 1.Mains voltage failure.
start again.
2.The drop between the
Fluomac and one of the tap
is too great.
3.The pump is out of order.
4.Fluomac is
malfunctioning.
The pump does not
1.There are big leaks in the
stop. system.
2.Fluomac is
malfunctioning.

7. TECHNICAL DATA

Power source: . . . . . . . . . . . . . . . . . . .
Max. current: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10 A
Operating pressure range: . . . . . . . . . . . .. .. 1÷3,5 bar / 14.5÷50,65 psi
Pre-set operating pressure: ................................... 1,5 bar / 21,8 psi
Max. allowable pressure: . . . . . . . . . . . . . . . . . . . . . . . . 10 bar / 145 psi
Max. liquid temperature: . . . . . . . . . . . . . . . . . . . . . . . . . . . .55° C/130° F
Pressure Drop to 100l/min: . . . ... . . . . . . . . . . . . . . . . . . . .... . . .0,7bar
Connections: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. . . . 1" GAS male
Protection level: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . IP 54
Type (Re. EN 60730-1): .......................................................... 1.B
SOLUTION
Check all
connections.
pressure too Turn screw
anticlockwise
direction.
Press
RESET button and make
sure the red light is off
when the pump stops.
1.Check the
connections.
2.Turn screw
clockwise (+) to increase
the operating pressure.
3.Consult an electrician.
4.Consult your dealer.
1.Check the system.
2. Consult your dealer.
110-230 VAC ±10% 50/60Hz
hydraulic
6
(-)
the
electrical
6 in