Use Of The Grinder; Overheat Protection; Cleaning And Maintenance; Safety Information - CASO DESIGN B 1800 Manual Del Usuario

14.3 Use of the grinder

1. Put the food which you want to grind into the grinder.
2. Assemble the grinder as described in "assembly".
3. Insert the plug.
4. Use the PULSE function or turn the knob to the desired speed (MIN-MAX) until the
desired consistency is reached.
► This device must not idle nor be overfilled, because the motor will overheat and gets
damaged. Fill the unit up to maximum of 60 percent.
► For hot food (up to a maximum of 80 ° C) only the blender jar can be used.
► Do not leave the device unsupervised when it is in operation.
► Remove power plug first before pouring out the food.

14.4 Overheat protection

In order to prolong the device's service life, an overheat protection is installed. If the motor
runs too long or overloaded, the temperature reaches the warning value and the motor will
stop automatically. Pull out power supply plug and wait for the motor to cool (about 20 to
30 minutes), then use again. If you have any problem with this device, do not disassemble
it by yourself. Always contact the service department or after-sale service department.

15 Cleaning and Maintenance

This chapter provides you with important notices with regard to cleaning and maintaining
the device. Please observe the notices to prevent damages due to cleaning the device
incorrectly and to ensure trouble-free operation.

15.1 Safety information

Please observe the safety instructions, before cleaning your device
► Unplug the device when not in use and before any cleaning.
► Never immerse the motor unit, cord or plug in water or other liquids and do not place in
the dishwasher.
► The blades of blade base and blades of blade grinder can be sharp. Handle them
carefully.

15.2 Cleaning

1. Fill the blender jar / Mix & Go bottle / grinder halfway with hot water, add a few drops of
detergent and let the device mix for 30 seconds with AUTO PULSE function. Rinse out
the blender jar / Mix & Go bottle / grinder thoroughly with lukewarm water and dry it.
2. You can clean all components EXCEPT the motor unit with running water and a litte
detergent.
3. Blender jar, lid of the blender jar, middle part of lid of the blender jar as well as the
Mix & Go bottle and its lid can be cleaned in the dishwasher.
Please note
Attention
38