Installation - Commercial Electric 56513241 Guía De Uso Y Cuidado

installation

Select a suitable location that can support the weight of the fixture. Determine the method of mounting before
drilling.
WarninG: RISK oF ELECTRIC SHoCK. Ensure the electricity to the wires you are working on is shut off. Either remove the fuse or turn off
the circuit breaker before removing the existing light fixture or installing the new one.
With power disconnected to your electrical box, remove the existing fixture. Make a sketch of how the current
fixture is wired (by wire color) or mark the wires with masking tape and a pencil so you will know how to properly
reconnect the wires to the new LED light fixture.
1
Separating the diffuser from the housing
□
Slide out the clip on the end cap of the wrap light housing (A).
□
Insert a finger into the hole and lift one side of the diffuser (B) and remove it from the housing (A).
End Cap
2
marking the mounting location
□
Temporarily hold the fixture housing (A) up to the ceiling to determine the best mounting position and which
knock out hole to use for wiring the fixture.
□
Mark four keyhole locations on the mounting surface.
Clip
B
A
Keyholes
4
A