Conceptronic C150BRS4 Manual De Instrucciones página 32

ENGLISH
1. Disconnect and reconnect the power of the router.
2. Disconnect and reconnect the network cable to the router and to your computer.
3. Renew the IP address of your computer with the following commands:
- 'IPCONFIG /RELEASE'
- 'IPCONFIG /RENEW'
If above steps do not solve the IP address issue, you can reset the device to the factory default settings
with the reset button on the back of the device.
Press and hold the reset button until the power LED starts to flash (about 10 seconds). This will reboot the
router and load the factory default settings into the router. When the power LED burns steady again,
repeat step B to renew the IP address.
Note: If the problem remains, check if all cables are connected in the correct way. The WAN port
should be connected to the modem and the LAN port to the computer. Connecting them in the
wrong way will also result in an incorrect IP address.
32
: this will release the incorrect IP address
: this will renew the IP address
3
3