BLACK&DECKER STORM STATION SS925 Manual De Instrucciones página 9

633374-00,02 SS925 1/11/06
A. Inverter
1. Set the 12Vdc and Inverter Selector
(4) to the "INVERTER" position.
2. The 12Vdc and Inverter Indicator (5)
will come on (green).
3. Ensure the rated power of the
appliance you are plugging in is
120Vac and not more than 25W,
otherwise the internal overload
protection will be executed and the
output of inverter will be cut off. For
output power greater than 20W, the
inverter may deliver the power to the
appliance for a shorter duration
(about 15 minutes).
4. Insert the plug of the appliance into
the Inverter Outlet (15) as shown in
figure D.
D
5. The output will be 120Vac 60Hz.
6. Switch on the appliance.
7. When the Inverter Outlet is not in use,
be sure the cap is kept closed.
B. 12Vdc Accessory Socket
1. Set the 12Vdc and Inverter Selector
(4) to "12V" position.
2. 12Vdc and Inverter Indicator (5) will
come on.
3. Insert the plug of the appliance into
the 12Vdc Outlet (14). Be sure the rated
voltage of the appliance is 12Vdc and
the rated current is not greater than
2.5A.
4. Switch on the appliance.
5. When the 12Vdc Outlet is not in use,
be sure the cap is kept closed to prevent
foreign material from entering the outlet
and causing a short-circuit.
WARNING: Do not insert a cigarette
lighter into the 12Vdc Outlet (14).
10:52 AM Page 9
C. Overload Protection
1. If the output current of inverter or
12Vdc Outlet is higher than the preset
limit, the Overload Indicator (11) will turn
on and the output will be disabled. The
12Vdc and Inverter Indicator (5) will turn
off.
2. Unplug the appliance and reset the
overload protection by pressing the
12Vdc and Inverter Reset Button (10).
The Overload Indicator (11) will turn off.
BULB REPLACEMENT (USE DC12V
0.4A BULB)
NOTE: If bulb has been lit, let it cool for
several minutes before changing.
A. Room Light
1. Open the cover of the room light as
shown in figure E.
E
2. Twist bulb until the "v" shaped notch in
rim of the bulb aligns with triangular
shaped retainer in the hole of the
reflective housing then pull straight out.
3. Insert new bulb by aligning the
triangular notch in the rim of the bulb with
the triangular tip retainer. Push in on bulb
and twist a half turn to lock bulb in place.
B. Flashlight
1. Unscrew the lens holder.
2. Turn the bulb holder slightly
counterclockwise and pull straight off.
3. Insert new bulb, place bulb holder over
bulb and turn slightly clockwise to lock it
in place.
4. Screw lens holder back on.
FLASHLIGHT BATTERY REMOVAL
(FOR RECYCLING)
Before attempting to disassemble the
flashlight, turn it on and leave it on until
the light goes completely out to ensure a
complete discharge of the batteries. Using
a phillips screwdriver, remove the screws
in the flashlight housing as shown in
figure F. Lift the batteries out and pull off
the terminal clips (figure G). See "Service
Information" for battery replacement.
9