Idiomas disponibles
Idiomas disponibles
R R e e a a r r P P a a n n e e l l
27
28
29
30
( ( 2 2 7 7 ) ) G G R R O O U U N N D D P P O O L L A A R R I I T T Y Y S S W W I I T T C C H H
Three position, rocker-type switch, which for most applications should be operated in the center (zero) position. If
hum or noise is present with the ground switch in the center position, place the ground polarity switch to positive
or negative (+ or -) to minimize hum; should a problem continue, consult your authorized Peavey dealer, the
Peavey factory, or a qualified service technician. N N O O T T E E : : The ground switch is not functional on 220/240 Volt
models.
( ( 2 2 8 8 ) ) R R E E S S E E T T / / C C I I R R C C U U I I T T B B R R E E A A K K E E R R S S W W I I T T C C H H
Use this switch to restore power to your unit when the internal breaker is tripped. The proper method is to turn
the power switch to the "off " position before resetting the breaker. To reset, push the reset button in and release
it. Turn the unit back on and confirm that the power LED is on. If the breaker is tripped again upon power-up,
consult your authorized Peavey dealer, the Peavey factory, or a qualified service technician.
( ( 2 2 9 9 ) ) P P O O W W E E R R S S W W I I T T C C H H
This switch is used to turn the MAX 700 on or off. To turn the unit on, flip the switch to the "on" position.
( ( 3 3 0 0 ) ) I I E E C C C C O O N N N N E E C C T T O O R R / / D D E E T T A A C C H H A A B B L L E E L L I I N N E E C C O O R R D D
For your safety, we have incorporated a detachable, three-wire line (mains) cord with proper grounding facilities.
It is not advisable to remove the ground pin under any circumstances. If it is necessary to use the amp without
proper grounding facilities, suitable grounding adaptors should be used. Greatly reduced shock hazard exists
when the unit is operated with properly grounded receptacles. Connect the IEC plug of your cord to the IEC socket
on the rear of your unit. Refer to the back of your unit for the proper voltage required before connecting to a
power receptacle.
( ( 3 3 1 1 ) ) P P O O W W E E R R C C O O R R D D R R E E T T A A I I N N E E R R S S
Use the Power Cord Retainers to wrap and store your cable while storing or transporting your MAX 700. It is best
to disconnect the cord from the unit before wrapping.
( ( 3 3 2 2 ) ) S S P P E E A A K K E E R R O O U U T T P P U U T T J J A A C C K K S S
These two 1/4" jacks provide the powered signal from the amplifier. Each connector is electrically the same (in
parallel). Use one of the jacks to connect your speaker cabinet and the other to add a second speaker cabinet in
parallel. The minimum speaker load impedance is 2 Ohms (or two 4 Ohm speakers in parallel). W W A A R R N N I I N N G G : : To
prevent the amplifier from overheating, the front fan and rear-located vents should always remain clear of
obstructions.
31
32
8
31
