Casals VMP1050EM Manual Del Usuario página 10

FITTING THE WORKING TOOLS (FIG. 1)
• Unplug the appliance from the mains.
• Only use tools with SDS-plus shaft.
• Clean and grease the shaft of the tool.
• Install the drill bit or accessory in the drill chuck. Turn the drill bit
slightly until it can be pushed in all the way and you can feel it
engages into place.
• Ensure that the drill bit is locked.
USE:
• Connect the appliance to the mains.
• Place the appliance against the surface you want to work.
• Press the appliance until the lengthways play is taken up.
• Turn the appliance on, by using the on/off button (H). Note: Exert-
ing high pressure does not increase machine effectiveness!
WARNING: When the bit begins to penetrate concrete or comes up
against the reinforcement rods in the concrete, the tool may react
dangerously. Make sure you keep your balance by distributing your
weight evenly and keeping your feet in a safe position whilst holding
the tool firmly in both hands to avoid dangerous reactions.
ELECTRONIC SPEED CONTROL:
• The speed of the appliance can be regulated by using the speed
regulator control (I). This function is very useful, as it makes it
possible to adapt the speed of the appliance to the type of work
that needs to be done.
DRILLING, DRIVING AND IMPACT DRILLING
• Drilling and driving:
• Turn the selector (C) until the arrow on the appliance points to (
DRILLING AND DRIVING (WOOD, STEEL ...):
• Turn the selector (C) until points to (
• To drill or screw, ALWAYS have the direction set to clockwise (CW).
).
)