Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Planing Tip: For a smoother appearance, fasten a
piece of scrap wood to the end of the piece you are
planing. Donʼt stop planing until the cutting blades of the
planer are past your work piece and into the scrap
material.
Blade Guard (Figure 7)
Ensure that the spring loaded blade guard (N) is in
proper working order before using the planer.
WARNING: Cut Hazard. Do not remove guard.
Rabbet Fence (Figures 8, 9)
WARNING: Turn off and unplug the tool before making any adjustments or
removing or installing accessories.
CAUTION: Allow the tool to reach full speed before
touching tool to the work surface. Lift the tool from the
work surface before turning the tool off.
The rabbet fence can be installed on either side of your
planer. The planer can make rabbet cuts up to .5 in.
(12mm).
TO INSTALL RABBET FENCE
a. Thread the knob (I) into the hole on the side of the
planer shown with arrow in figure 8.
b. Loosen the rabbet fence adjustment knob (H) and
adjust fence to desired distance.
c. Securely tighten rabbet fence adjustment knob (H).
d. The rabbet fence should be below the planer
when installed correctly as shown in figure 9.
TO MAKE A RABBET CUT
a. Turn the rabbet fence adjustment knob (H) to
adjust the desired width of cut.
b. Make several cuts until the desired depth is
reached.
NOTE: It will be necessary to make quite a few cuts for
most rabbet applications.
5
6
7
8
H
9
7
N
I
Tabla de contenido
