Setup; Setup Location Requirements; Electrical Connection - CASO DESIGN DG 2000 Manual De Instrucciones

12.5 Setup

12.5.1 Setup location requirements:

In order to ensure the safe and trouble-free operation of the device, the setup location
must fulfil the following prerequisites:
• The appliance must be positioned on a solid, even, horizontal and heat-resistant base
with sufficient load-supporting capacity for the appliance itself plus the heaviest
anticipated cooking contents.
• Select an installation location where children cannot reach the appliance's hot surface.
• Do not set up the device in a hot, wet or extremely damp environment or near
flammable material.
• Do not use the appliance near flammable materials such as curtains, kitchen towels,
wooden surfaces, etc.
• During operation of the appliance, there needs to be sufficient area for air circulation
above the appliance and on all its sides.
• Do not use the appliance outdoors.
• The device is not intended to be installed in a wall or a built-in cupboard.
• The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
• The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they
guarantee the prerequisites for the safe use of this device.

12.6 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the following
instructions must be observed for the electrical connection:
• Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device.
If in doubt, ask your qualified electrician.
• The connection between the device and the electrical network may employ a 3 meter
long (max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs
or gangs
is prohibited because of the danger of fire that is involved with this.
• Make sure that the power cable is undamaged and has not been installed under the
oven or over hot or sharp surfaces.
• The electrical outlet must be protected by a 16A safety cut-out switch.
• The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. If in doubt, have the house installation
checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages that are caused by a
missing or damaged protective conductor.
30