Glacier bay 874-0101 Guía De Instalación Y Cuidado página 8

Installation (continued)
3
Installing the supply
connections
NOTE: The hot water supply lines go into the H inlet, and
the cold water supply lines go into the C inlet. Do not use
PEX or CPVC between the valve and spout.
□
Wrap thread sealant tape (not included) around
the pipe threads in a clockwise direction, as
shown.
□
Connect the hot and cold water supply lines (1,
not included), the shower outlet pipe (2, not
included), and tub outlet pipe (3, not included)
by threading them into the valve body (D) in a
clockwise direction.
□
Tighten the pipes to the valve body (D) with a
pipe wrench (not included).
□
Connect the pipe elbows (4, not included) to
the end of the shower outlet and tub outlet
pipes.
NOTE: If you do not wish to install the tub outlet, insert
the plug (I) into the bottom of the valve body (D).
D
H
D
1
D
1
4
2
3
4
2
I
4
Back to back installation
□
If the hot and cold inlets are reversed (hot on
right and cold on left), remove the screw, inverter,
sleeve, and bonnet from the valve body (D) with
reversed supply connections. Rotate cartridge
180°, so H appear on the right. Install the cartridge
making sure that the key is fully engaged with the
slot in the valve body (D). Slide bonnet over the
cartridge and thread onto the body. Hand tighten
securely. Reassemble sleeve, inverter and screw.
If you are not making a reverse or back to back
installation, skip the step, continue with the step 5.
NOTE: Never install the valve body (D) upside down!
Cold
Reverse
installation
8
Normal
installation
(changes
not required)
Cold
Hot
Hot