HAMPTON BAY WINDWARD IV Guía De Uso Y Mantenimiento página 8

Assembly -Close-To-Ceiling Mounting
1
Close-to-Ceiling Mounting
Remove canopy ring from the canopy (C) by turning the
ring to the right until it unlocks.
Remove the mounting bracket (A) from the canopy (C) by
loosening the four screws on the top of the canopy (C).
Remove the two non-slotted screws and loosen the
slotted screws.
Remove the decorative canopy bottom cover (L) from the
canopy (C) by depressing the three studs.
Remove three of the six screws and lock washers (every
other one) securing the motor collar to the top of the fan
motor housing.
Place the rubber gasket (FF) over the remaining three
screws, route the wires exiting the top of the fan motor
through the canopy ring (make sure the slot openings are
on top), then proceed to place the ceiling canopy (C) over
the collar at the top of the motor.
Align the mounting holes with the holes in the motor and
fasten, using the three screws and lock-washers removed
previously. Tighten the mounting screws securely.
Assembly – Hanging the Fan
4
Attaching the fan to the electrical
box
WARNING: To reduce the risk of re, electric shock, or
other personal injury, mount the fan to an outlet box or
supporting system marked acceptable for fan support, and
use the mounting screws provided with the outlet box.
Pass the 120-Volt supply wires through the center hole
in the mounting bracket (A).
Install the ceiling mounting bracket on the outlet box by
sliding the mounting bracket (A) over the two screws
provided with the outlet box. If necessary, use leveling
washers (not included) between the mounting bracket
(A) and the outlet box. Note that the at side of the
mounting bracket (A) is toward the outlet box. When
using close-to-ceiling mounting, it is important that the
mounting bracket be level.
Securely tighten the two mounting screws.
5
Hanging the fan
Carefully lift the fan-motor assembly (D) up to the
mounting bracket (A).
Seat the hanger ball portion of the ball/downrod assembly
(B) in the mounting bracket socket. Ensure that the tab on
the mounting bracket (A) socket is properly seated in the
groove in the hanger ball. If using close-to-ceiling
mounting, hang the fan on the hook provided by utilizing
one of the holes at the outer rim of the ceiling canopy.
WARNING:
The hook as shown is only to balance fan while
attaching wiring. Failure to hang as shown may result in the
hook breaking, causing the fan to fall. Hook must pass from
inside to outside of canopy.
A
D
8
C
L
C
FF
D
A
B
D