Miscellaneous; Warranty Conditions; Disclaimer; Waste Disposal - BEGA BETEX BLF 200 Manual Del Usuario

10. Miscellaneous

3

10.1 Warranty conditions

Bega as manufacturer offers 12 months' warranty on the hardware of the original product. The
warranty period commences on the date of delivery to the end user. Claims under warranty must be
accompanied by a proof of purchase with delivery date. Within this period, Bega shall remedy defects
resulting from production and/or material faults.
1. A defect or fault must be reported immediately in order to avoid possible consequential
damage.
Warranty claims will be voided if the defect or fault is not reported immediately.
2. The warranty does not cover defects resulting from failure to observe the installation, safety
and operating instructions given in the user manual.
3. The warranty does not apply to damage resulting from:
- Contact with aggressive substances,
- Exposure to water,
- Abnormal ambient or environmental conditions,
- Inappropriate operating conditions or conditions of use.
4. Unauthorised modifications or modifications by third parties will void the warranty. The
replacement of parts with non-OEM parts will also void the warranty.
5. The product must be sent to the manufacturer's Service department for repair.
6. A repair by Bega within the warranty period will not result in a commencement of a new
warranty period nor in a prolongation of the original warranty period.
7. Other claims for damages, such as damage occurring outside the product, will not be
accepted.
8. Wear and tear parts such as gloves and temperature sensors are not covered by the warranty.
9. For further provisions, refer to the General Conditions of Sale and Delivery of Bega
International BV.

10.2 Disclaimer

The manufacturer and/or supplier cannot be held liable for any damage to workpieces or
consequential damage resulting from incorrect use of the device or damage to workpieces and any
consequential damage resulting from a defect in the device.

10.3 Waste disposal

Power tools, accessories and packaging must be reused at the end of their life cycle in an
environmentally sound manner.
Do not dispose of used power tools as residual waste, but bring them to a recycling
company that complies with the applicable environmental requirements.
20