Heating A Horizontal Workpiece - BEGA BETEX BLF 200 Manual Del Usuario

•
Swivel arm models: swivel the yoke open (towards you) until it clicks in the safety positioning cam.
Slide the workpiece over the yoke until it is in the middle.
Swivel the yoke back to the pole.
•
Always make sure that the workpiece does not come into contact with the plastic casing of the
heater. When the heating is finished, follow the instructions in reverse order. Use heat-resistant
gloves to move the heated workpiece.

6.2 Heating a horizontal workpiece

•
This is only possible if the bore of the workpiece is large enough to fit over the pole.
•
Place the workpiece as centrally as possible around the pole on the horizontal supports.
•
The workpiece may not be wider than the horizontal supports.
•
Always choose the largest induction yoke.
•
Make sure that the bare-metal sides are sufficiently coated with Vaseline to ensure optimal contact
and avoid vibration.
•
Always make sure that the workpiece does not come into contact with the plastic casing of the
heater. When the heating is finished, follow the instructions in reverse order. Use heat-resistant
gloves to move the heated workpiece.
14